1966-1970 Ford Mustang & FE, 390, 428 Engine Parts (Naples)
69 Interior Quarter Trim Caps (pair) - $5
Fills the gap between the rear interior quarter panel and the sail panel in the corner where the pinch on windlace ends. Average condition original part.
FE Accel Distributor - Offer?
Came off of my 428 when I went with a new setup and has a new gear on it. Bearings and gear are new. Includes cap and rotor. Has some black paint up the side and could use a good cleaning. Dual points with no vacuum advance and a tach drive setup.
60-63 352 FE Distributor - $5
Single points distributor with vacuum advance. Could use a rebuild. No cap or rotor. Was told it was 390/428 when I picked it up, but the C0AF12127D (1FB) number says otherwise.
NOS C90B12250A Wiring Harness - Offer?
New with Ford tag still attached. Master Parts Catalog says it is the pink resistor wire used for the coil.
FE Single Groove Crankshaft Pulley - Offer?
C5TE-6312-A single groove pulley. Straight and true. Nice shape and was used on my 428 until I swapped over for a correct date coded setup and added power steering.
66-69 390/428 harmonic balancer - Offer?
C6AE-6316A (L138664). Date coded A6 (January 1966). Was on my 428 until I swapped for a correct date coded setup. Great shape.
66-69 390/428 Timing Pointer - Offer?
Screws onto timing chain cover. Was used in conjunction with the balancer. Near perfect shape.
67/68 289/302 Pressure Side Power Steering Hose - Offer?
Brand new, never used. Pressure side hose from the pump to the control valve. I ended up using the P/S setup on my 70 and this hose will not work for what I need.
05-10 Mustang GT Spectre Air Filter - Free (just pick up the shipping)
Re-oiled and ready to go. Similar to K&N.
69 Lower Steering Column Cover - $15
Small hairline crack up the center section that is not noticeable unless you really look for it. Installed you would never know it had a hairline crack in it. Already painted black and in otherwise great shape.
68-71 302/351/390 Clutch Fork - Offer?
C8AA-7515-B clutch fork. Great shape. Should fit 68-71 small blocks and the 390. Measures 12 5/16" long and uses the riveted clip.
70 Turn Signal Switch - Free (just pay the ride)
Defective so it was replaced. If anyone wants it for some project or idea, it's yours. Otherwise it is headed for the trash.
67-70 Pitman Arm - $20?
Has been media blasted and primered. For manual steering cars. I believe it is a 1 1/8" diameter sector shaft fitment. Great shape, but I swapped over to PS.
69/70 302/351? Power Steering Bracket - $5?
I believe this is correct for a 69/70 302/351 (I couldn't find any part numbers on it though). It's in good shape but it could use a decent cleaning and some paint.
Small Block (302/351)? Power Steering Pulley - $5?
Not entirely sure what this is correct for as I could not find a part number anywhere on it. It measures approximately 6 1/4" across and has a sheeve width of approximately 5/8" from inside lip to inside lip. I was told it came off of a small block 69 Cougar when I picked this part up. Please someone chime in if this is incorrect as I do not want to misadvertise it.
69/70 (?) Fastback Rear Seat Stop (non-fold down) - Offer?
Extra pair of 69 or 70 (I know 70 for sure) rear seat stops for the non fold down seat. The upper portion of the rear seat gets stopped by this and then is secured to the rear package tray to keep it in place. Again, no idea what it goes for so make me an offer?
70+ Rimblow Steering wheel and pad - $150
Needs restoration. Pad was repainted black from green at some point and the paint is starting to flake off in places. Missing the 3 inserts, but has the center running pony insert. Wheel itself has the usual cracks. I was going to have it restored, but I decided to put the money elsewhere and just look for a decent driver quality wheel instead.
- do NOT contact me with unsolicited services or offers